What are the reasons for vacuum pump exhaust filter Loss & Blockage problems and how to solve them?

The common problems of vacuum pump oil mist separator are resistance loss and blockage. What are the reasons for these two problems and how to solve them?

1. Resistance loss

To solve a problem, you need to find the root cause of the problem. The same is true for the resistance of the vacuum pump filter element. You must find the reason for the resistance loss and what causes the filter element to be blocked, so that you can find a way to match the cause.

  There are two key reasons for the resistance of the vacuum pump filter element:

1.Change the geometry looks. In this case, the filter element should be removed to see the level of deformation. If it is slightly deformed, it can be repaired and used again. If it is moderately deformed, do not use it again, otherwise it will aggravate the damage of the vacuum pump.

2. High-temperature air oxidation and the atomization of water droplets cause the presence of impurity particles in the vacuum pump exhaust  filter element, which causes the filter element to be damaged. Some are left over from cleaning. At this time, it is necessary to completely clean the oil separator filter element. First, use a soft brush or hair dryer to remove the impurity particles, and then use a cleaning agent to clean it up without leaving impurities, so as to avoid secondary pollution. The above are two methods to solve the resistance of the vacuum pump oil mist  filter element. I hope that everyone can use it properly and maintain it to increase its service life as much as possible.

2. Blockage

  A reasonable way to solve the blockage is to install the vacuum pump air intake filter element. The vacuum pump oil mist filter element will undoubtedly filter some impurities in the water or oil when it is working. After installing the vacuum pump air intake filter element, it will absorb the dirt in the water and oil. , so as to ensure that the vacuum pump works in a clean natural environment, which will prevent the vacuum pump from causing blockage. In addition, in addition to the problem of blockage, the vacuum pump filter element must also pay attention to the usual maintenance. The staff should carefully listen to the sound of the vacuum pump for noise, check whether there are impurities attached to the vacuum pump exhaust mist  filter element, and check whether there is oil at the air outlet. Once an abnormal condition occurs, the master should be repaired or replaced immediately.

  The maintenance of the vacuum pump should not be sloppy, and the filter element of the vacuum pump should also be checked, and problems should be dealt with in time. Don't panic when you encounter these two problems, check carefully and analyze calmly.